zigpy / bellows / 933 / 5
100%
master: 100%

LAST BUILD BRANCH: dm/zhared-ci-update-with-ruff
DEFAULT BRANCH: master
Ran
Files 16
Run time 1s
Badge
Embed ▾
README BADGES
x

If you need to use a raster PNG badge, change the '.svg' to '.png' in the link

Markdown

Textile

RDoc

HTML

Rst
coverage: 100.0%. Remained the same
TOXENV=py38

push

travis-ci

web-flow 
Update README.md with more introduction descriptions about EmberZNet interfaces for new developers (#262)

* Update README.md with more introduction descriptions for new developers

Update README.md with more introduction descriptions for new developers. Much of this information been copied from zsmartsystems readme https://github.com/zsmartsystems/com.zsmartsystems.zigbee/blob/master/README.md which by the way contains even more information which I was not sure if it should also be copied as well or not, please see:

### Silicon Labs Ember EM35x / EFR32

The library supports the Silicon Labs EZSP (EmberZNet Serial Protocol) APIs for EM35x and EFR32 SoCs using ASH or SPI protocols over a serial interface. The implementation of the SPI protocol assumes that the SPI provides a TTY-like software interface to the application, or is otherwise abstracted via the ```ZigBeePort``` interface.  

It is worth noting that EM3588 devices that have an embedded USB core will likely work with any baud rate, where dongles using external USB interface (eg CP2102 used with an EM3581) will likely require a specific baud rate.

Silabs did use to provide two main NCP images pre-build with firmware for EM35x, one image supported hardware flow control with a baud rate of 115200 and the other image supported software flow control with a rate of 57600. 

Silicon Labs no longer provide pre-build firmware images, so now you have to build and compile firmware with their Simplicity Studio SDK for EmberZNet PRO Zigbee Protocol Stack Software. Simplicity Studio is a free download but building and compiling EmberZNet PRO Zigbee firmware images required that you have the serialnumber of an official Zigbee devkit registered to your Silicon Labs user account.

#### Ember NCP configuration

The library provide a standard set of configuration constants to configure the NCP for use as a coordinator. There are two methods available in the Ember driver to manipulate the confi... (continued)

1773 of 1773 relevant lines covered (100.0%)

1.0 hits per line

Source Files on job 933.5 (TOXENV=py38)